Differences

This shows you the differences between two versions of the page.

--- install [2018/01/10 00:38] – Minor change. Deleted comma walter_schulz
+++ install [2021/04/11 09:50] – [Troubleshooting] Walter Schulz
@@ Line 65: / Line 65: @@
   * If you prefer to skip the firmware update step and prepare your cards from the PC, you may copy ML files on your card and make it bootable with a special utility: **[[http://pel.hu/down/EOScard.exe|EOScard]]** for Windows, **[[http://www.zenoshrdlu.com/macboot/macboot.html|MacBoot]]** for Mac, or **[[https://bitbucket.org/hudson/magic-lantern/src/tip/contrib/make-bootable|make_bootable.sh]]** for Mac/Linux in command line.
+This table below explains where magic strings must be written depending on FAT version (done by tools above):\\
+^FAT version^Volume Label = "EOS_DEVELOP"^Bootcode+2 = "BOOTDISK"^"SCRIPT"^
+|FAT12/16 	|0x2b/43|0x40/64 |0x1f0|
+|FAT32 	| 0x47/71 	|0x5c/92 	|0x1f0|
+|ExFAT 	|0x82/130 	|0x7a/122 |0x1f0|
+VBR checksums must be updated for ExFat\\
+SCRIPT is for Canon basic.
 ====== Updating Magic Lantern ======
@@ Line 93: / Line 100: @@
   * **DO NOT use a bootable card without a working autoexec.bin on it!** If you do, remove the battery immediately, switching the camera off is not enough !!!
   * Check the [[https://bitbucket.org/hudson/magic-lantern/issues|issue tracker]] for similar problems; if you can't find the solution, create a new issue there.
+  * If you get "ML directory not found! Please copy all ML files." during installation -> [[faq#during_installation_error_message_ml_directory_not_found_please_copy_all_ml_files_appears|FAQ]].
 ====== Important notes ======