digic8:registers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
digic8:registers [2022/02/20 17:04] – [LV peaking (Highlights / zebra)] kitor | digic8:registers [2022/02/21 23:03] (current) – [LV peaking (Highlights / zebra)] kitor | ||
---|---|---|---|
Line 40: | Line 40: | ||
Registers used by '' | Registers used by '' | ||
- | ===Note on HDMI registers=== | + | Different addresses and slightly different values than Digic 6/7, but capabilities are very similar. |
- | Directly poking HDMI enable doesn' | + | |
- | + | ||
- | On R180.739 I was able to follow xrefs to that register, and found a function that writes them - on R180.739 source value is stored in '' | + | |
__It is possible to have independent zebras configured on LCD and HDMI while running in Clean HDMI mode!__ | __It is possible to have independent zebras configured on LCD and HDMI while running in Clean HDMI mode!__ | ||
+ | |||
+ | ===Note on directly writing the registers=== | ||
+ | Directly writing some registers doesn' | ||
+ | |||
+ | TL;DR is that you need to find (via xrefs / static code analysis) where reg value is stored, and update that memory address instead. | ||
===Enable register=== | ===Enable register=== |
digic8/registers.1645373046.txt.gz · Last modified: 2022/02/20 17:04 by kitor